Compaq Cabinet H9A11 - Manual (Page 15)

Installation
H9A11 Cabinet Installation/Owner's Guide 2–3
2.4 Unpacking
The cabinet is shipped on a wooden pallet. Proceed as follows to unpack the cabinet:
1. Position the pallet with the cabinet in an area that provides sufficient workspace for
unpacking. Ensure that there is sufficient clearance in front of the pallet (marked with a
large F) to roll the cabinet down the ramps.
2. Refer to Figure 2-1. Cut and remove the plastic wrapping
™ that secures the corner
posts
š and the carton › to the cabinet. The carton contains the two ramps.
3. Remove the corner posts
š and the carton › from the pallet œ.
_________________________ Caution ___________________________
In the next step, take care not to damage the cabinet finish when removing the
shrinkwrap.
____________________________________________________________
4. Remove the plastic bag
 covering the cabinet.
5. Check the cabinet and the associated equipment for any external damage. Report any
damage to Compaq Customer Service or a Compaq sales office and to the responsible
freight carrier.
__________________________ Note _____________________________
Keep all packing material and receipts in case a damage claim is filed.
____________________________________________________________