Acura 2015 MDX - Owner's Manual (Revised 12/12/2014) - Manual (Page 467)

466
uu Jump Starting u
Han
d
lin
g the U
n
expected
5. Connect the other end of the second
jumper cable to the engine hanger as
shown. Do not connect this jumper cable to
any other part.
6. If your vehicle is connected to another
vehicle, start the assisting vehicle’s engine
and increase its rpm slightly.
7. Attempt to start your vehicle’s engine. If it
turns over slowly, check that the jumper
cables have good metal-to-metal contact.
Once your vehicle’s engine has started, remove the jumper cables in the following
order.
1. Disconnect the jumper cable from your vehicle’s ground.
2. Disconnect the other end of the jumper cable from the booster battery -
terminal.
3. Disconnect the jumper cable from your vehicle’s battery + terminal.
4. Disconnect the other end of the jumper cable from the booster battery +
terminal.
Have your vehicle inspected by a nearby service station or a dealer.
■ What to Do After the Engine Starts
15 ACURA MDX-31TZ56100.book 466 ページ ２０１４年１１月２８日 金曜日 午後５時１７分