AERCO CXT-E Retrofit Kit - Manual (Page 38)

ECS and CXT-E Retrofit Instructions Kit # 27004-TAB
Technical Instruction Document TID-0141_0A
12/30/2014 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 • Phone: 800-526-0288 Page 38 of 76
SHAFT PIN
LOCATION
LINKAGE ADAPTER
INDICATOR
PLATE
0
1
LINKAGE
ASSEMBLY
SCALE
PACKING NUT
VALVE TOP
LINKAGE
GASKET
HEX NUTS (2)
VALVE SHAFT
VALVE BODY
5
CAP SCREW
8-32 HEX NUT
(FAR SIDE)
4
INDICATOR PLATE
(CURVED END)
3
2
1
ITEM QTY PART DESCRIPTION PART NUMBER
1 1 LINKAGE ASSEMBLY 24038-1 (1” TO 3” VALVES)
2 1 SCALE
59028-1 (1” VALVE)
59028-1.25 (1.25” VALVE)
59028-1.5 (1.5” VALVE)
59028-2 (2” VALVE)
59028-2.5 (2.5” VALVE)
59028-3 ( 3” VALVE)
59028-4 (4” VALVE)
3 2 8-32 HEX NUT 123322
4 2 3/8-16 X 5/8 LONG CAP SCREW 54014
5 1 GASKET 81046
Figure 4-3. Linkage Installation Details
4.1.2 Actuator Installation
Remove the Actuator Assembly (69170) from the Retrofit Kit and install as follows:
1. Depress and hold the Clutch Button (Figure 4-4) and rotate the pointer to approximately 80°
on the dial. Release the Clutch Button when properly positioned.
CAUTION
DO NOT DEPRESS THE CLUTCH BUTTON WITH POWER APPLIED
TO THE ACTUATOR