Allersearch Compact Space Chamber Plus - Manual

Priming your Space Chamber Plus ®
Before using the Space Chamber Plus ® for the first time it will
need to be primed. To prime the Space Chamber Plus ® , immerse
in warm water with mild liquid detergent. Do not rinse and allow to
air dry. Alternatively the Space Chamber Plus
® may be primed by
depressing your inhaler 2-4 times into the Space Chamber Plus ® .
Your Space Chamber Plus ® is now ready to use.
Your Space Chamber Plus ® will need to ’primed’ again if it is only
used occasionally.
How to use the Space Chamber Plus ®
1. Remove the cap from your inhaler and shake well.
2. Push the inhaler into the base of the Space Chamber Plus ® .
3. Put the mouthpiece between the lips and make an airtight seal,
depress your inhaler, you will see a fine spray inside the Space
Chamber Plus ® . Take a slow, deep breath through the mouth
and hold for 5-10 seconds or continue to breathe in and out
through the Space Chamber Plus
® for 4-6 breaths.
4. Wait at least one minute before repeating step 3. Only use one
dose from the inhaler at a time.
5. If a face mask is needed, fix to the Space Chamber Plus ® and
follow steps 1-4.
Please note
Always follow the instructions provided with your inhaler.
Before use check for foreign objects, broken or deteriorated parts.
Replace Space Chamber Plus ® immediately if any damaged or missing
parts are evident.
Check to see that the valve in the mouthpiece moves when you
breathe in and when you breathe out.
All components used in the Space Chamber Plus ® are latex free.
1
2
3
4
5
®
Compact
Space Chamber
Usage instructions
Space Chamber Plus ® is a registered trademark of:
Medical Developments International Limited ABN 14 106 340 667
7/56 Smith Road Springvale Victoria 3171 Australia
Telephone +61 3 9547 1888 Fax +61 3 9547 0262
Email: [email protected] Web: www.medicaldev.com
Distributed by:
EBOS Group PTY LTD. ABN 38 125 401 247
Unit 2, 109 Vanessa Street Kingsgrove, NSW 1480
www.eboshealthcare.com.au
www.ebosonline.com.au
product insert IFUp1.pdf 1 7/06/12 10:49 AM