Allersearch Nomad Nexgen Battery - Manual (Page 3)

INSTRUCTIONS FOR USE
Attention: Refer to the battery charging instructions before using.
1. Connect the battery to the power supply unit (1.) and then to the mains power (fig.
A). Alternatively use the car-lighter socket (fig. B) and the car lighter cable (12V DC)
(2.).
2. The battery is charged when the LED (3.) turns green.
3. Remove the battery contact cover located at rear of the unit (fig. C) and attach the
battery correctly by using the locating spigot and ensuring that the locking tabs are
in place (fig. D).
4. The battery has a multicolour LED (3.) indicating the battery charge level. With the
battery fitted on the unit, press button of the NOMAD ¤ NexGen and the LED will
indicate the battery charge level.
• Green LED = battery charged
• Orange LED = less than 50% battery charge remaining
• Red LED
= battery low; immediately recharge
TECHNICAL SPECIFICATIONS
Type: 12V 1300mAh
Operating time with fully charged battery: approximately 45 minutes (at 25°C approx.)
Battery charging option:
power supply unit or car lighter cord
Minimum charge time: 6 hrs approx
Manufactured to comply with
Medical Directive: 93/42 EEC
and STD. EN 60 601-1
Operating conditions: Temperature: min 10°C; max 40°C
Air humidity: min 10%; max 95% RH
Storage conditions: Temperature: min -20°C; max 40°C
Air humidity: min 10%; max 95% RH
Operating/storage
atmospheric pressure:
min 690 hPa; max 1060 hPa P
0051 N13211
To safeguard the environment, when the battery has reached the end of its life
take it to an authorised electric appliance disposal centre where the raw materials
can be recycled. Please check to see if this is applicable in your area.
Disposal
the battery under running water or by soaking. Keep away from sprays of water or
other liquids.
- Do not expose the Battery to cold temperatures.
- Do not place the battery near sources of heat, in direct sunlight or in excessively
warm environments.
Use only ALLERSEARCH approved batteries.