Chicago Electric 92880 - Manual (Page 11)

Page 11 For technical questions, please call 1-800-444-3353. SKU 92880
Figure 10
5. Pass the end of the Flexible Shaft Core
through the Collet Nut, and into the 1/8”
Collet. Depress the Spindle Lock (10),
and hold it down while tightening the
Collet Nut with the Wrench.
When the Collet Nut is tight, release the 6.
Spindle Lock (10) and turn the Flexible
Shaft Attaching Nut clockwise onto the
tool body until hand tight.
Installing a Bit in the Flexible Shaft
Wrench
“L” Tool
Figure 10
Loosen
Tighten
1. Use the Round “L” Tool to prevent the
Flexible Shaft Core from turning by
inserting it into the hole in the side of the
Flexible Shaft Handle.
Once “L” tool is in place, remove 2.
the Collet locking nut by turning it
counterclockwise with the Wrench.
Place the bit into the appropriate sized 3.
collet. Place the collet into the end of the
Flexible Shaft Handle. Place the Collet
Locking Nut over the bit, and tighten it by
turning clockwise. Tighten in place using
the Wrench, and the Round “L” Tool as a
hold back.
Installing or Removing Collars
The Front Collar (3) is interchangeable
with the LED Lighted Attachment (23).
Figure 10
1. To install the LED Lighted Attachment,
remove the standard collar by turning
counterclockwise, and install the LED
Lighted Attachment by turning clockwise.
note: When installing or removing, use only
hand pressure and tighten firmly by
hand. Do not overtighten, as this may
damage the part.
To change the batteries in the LED 2.
Lighted Attachment, first remove it from
the Rotary Tool.
Figure 10
3. Using a phillips screw driver, open the
battery compartment.
Figure 10
4. Replace the batteries with the same type
as originally installed (Two CR-927 3
VDC batteries). Be sure to match the
polarity marking in the battery
compartment.
REV 10e