American Diagnostic Corporation (ADC) Diagnostix 2100 - Manual (Page 3)

the device and device components, including batteries.
WARNING: This product may contain a chemical known to the state of California to cause cancer,
birth defects, or other reproductive harm.
CAUTION: Do not use the pulse oximeter in an explosive atmosphere.
CAUTION: SpO2 and pulse rate data is displayed for informational purposes only and does not con-
stitute a diagnosis or medical advice of any kind. Only a qualified healthcare professional should in-
terpret the data obtained on this device.
CAUTION: Check the pulse oximeter sensor application site frequently to determine the positioning
of the sensor and circulation and skin sensitivity of the patient.
CAUTION: The pulse oximeter is not for continuous monitoring.
CAUTION: Prolonged use or the patient's condition may require changing the sensor site periodically.
Change sensor site and check skin integrity, circulatory status, and correct alignment at least every 4 hours.
CAUTION: Inaccurate measurements may be caused by autoclaving, ethylene oxide sterilizing, or im-
mersing the sensors in liquid.
CAUTION: The device should not be used on an extremity with a blood pressure cuff, arterial
catheter, or intravascular line.
Brief Description of Front Panel
Included Pulse Oximeter Accessories
• One (1) lanyard
• Two (2) AAA batteries
• One (1) user manual
Battery Installation
1. Remove battery compartment cover by de- •
pressing button on battery cover top, then
slide cover in the direction of the arrow, then
tilt upward on hinge.
2. Insert two AAA batteries into battery com- •
partment being sure to observe the correct po-
larities.
3. Replace the battery cover by reversing step •
1. (Figure 1)
Note: Be sure to observe correct battery polar-
ity. Failure to do so might damage the device. If
device will not be used for an extended period of time, remove batteries. Replace batteries
when low battery symbol appears on display. Always replace BOTH batteries at the same time.
SpO
2
Pulse Rate Signal
Intensity Bar Graph
Pulse Rate
Power Switch
Low Power
Indicator
SpO
2
Waveform
(Figure 1)