Setup, Operation, Caution – Antari M-8 User Manual

Page 6

Advertising
background image

6

Setup

․

Remove all packing materials from shipping box. Check that all foam and plastic padding

is removed, especially in the nozzle area.

․

Place fog machine on a flat surface and remove fog liquid tank cap.

․

Fill with high-quality, water-based fog liquid recommended by Antari dealer.

․

When filled, place cap back on liquid tank.

․

Firmly attach the M-21 control module cable to the connector inside the rear chamber for

the machine.

Operation

․

Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the

back of the machine. Warm-up is completed when the display on the control module

shows “Ready to Fog”

․

To emit fog press the appropriate button on the M-21 control module for fogging duration,

interval and volume

․

The control unit display will display “Warming up” and “Ready to fog” as the machine

re-heats to the proper operating temperature.

․

For further information on operating your M-8 Fog Machine, see the section titled

“Control Module Operation”

․

The limited warranty is based on 8-hour operation per day. Exceeding usage may

shorten the lifetime of machines.

Caution

”Visibility during operation is reduced” This model can be operated at a floor level or sitting

on any regular surface. Whatever installation method you choose, do not allow the unit to

have more than 35 degree angle of inclination.

Advertising