AOC 712S - Manual (Page 7)

6
CONTROLS AND CONNECTORS
VIDEO CABLE
Connecting the Signal Cable: the LCD monitor comes with a built-in signal
cable. Plug the signal cables 15-pin connector into the computer's VGA port
and tighten the two screws on the cable connector.
Connecting the Power Cord: Connect the power cord into your LCD
monitor’s power input socket, and then plug the other end into a 3-pin AC
power outlet. The power cord may be connected to either a wall power outlet
or the power outlet socket on your PC, depending on the type of power cord
supplied with your LCD monitor.
Caution: If the AC outlet is not grounded (with three holes), install the proper
grounding adapter (not supplied).
1
Figure 2 Connecting Cables
1. AC Power Cord
2. D-Sub Cable