AquaCraft Air Force - Manual (Page 8)

❏
11. Screw the clevis onto the throttle pushrod and attach
it to the inside hole of the throttle lever.
❏
12. Finish the throttle cable installation by placing a couple
of drops of thin CA where the cable goes through the engine
mounting plate.
❏
13. The engine cowl has been pre-cut but you may have
to make modifications based upon which engine you are
installing. Next, place the cowl over the engine and secure it
to the plywood using the four 2.5 x 8mm panhead self-
tapping screws.
❏
14. Attach the muffler.
Refer to page 4 for spinner and prop installation.
❏
1. Cut two X-shaped servo arms as shown. This will cut
down the chances of any radio wiring getting tangled in the
radio compartment.
❏
2. Install the throttle and rudder servos with rubber
grommets and mounting screws.
❏
3. Center the servos as indicated in the radio system
instructions.
❏
4. Attach the servo arms and screws to the servos and
attach the throttle and steering linkages as shown.
INSTALL THE SERVOS
8