AquaCraft Minimono - Manual (Page 6)

6
MAINTENANCE
It is important to remove and relubricate the drive shaft after
a day of running. Make sure the battery pack is unplugged.
To lubricate the cable you will need a1.5mm hex wrench,
GrimRacer Speed Grease and some paper towels.
Using a 1.5mm hex wrench, loosen the set screws holding
the drive cable to the motor coupler. It is important to note
that there are two set screws holding the cable in position.
Slip the drive shaft out the back of the boat. Wipe off
any grease and water that might be on the shaft.
Using GrimRacer Speed Grease, apply a small amount to the
shaft and slide the cable back into the boat. Be careful to align
the drive shaft to the hole in the end of the motor coupler.