AquaCraft Rio 51 - Manual (Page 10)

❏
5. Off or stop position. If this is not the case, move the
steering servo reverse switch located on the front of the
transmitter (2) to the other position. Note: You might have
to readjust the position of the throttle arm of the throttle
servo to properly get the carburetor to match the pictures.
INSTALLING THE PROPELLER
❏
1. Use a 10mm wrench to remove the prop nut from the
stub shaft.
❏
2. Install the propeller on the shaft; replace the nut,
making sure it is tight.
❏
3. Assembly is now complete.
10