AquaCraft SuperVee 27R - Manual (Page 9)

9
SHAFT MAINTENANCE
After each 5 or so runs and after your day of running it’s a good
idea to re-lubricate the drive cable. Here are the tools and supplies
you need to complete the task.
10mm open end wrench
12mm open end wrench
AquaCraft Grimracer Speed Grease (AQUB9500)
Paper towel
Let’s begin.
1. Loosen the cable coupler using the 10 and 12mm wrenches.
2. Firmly pull the prop and drive shaft out of the back of the boat.
Wipe away any old grease and water.
3. Apply new speed grease to the shaft and slide it back into
the strut, moving it in and out as you do so to help spread the
grease along the length of the cable.