AquaCraft V24 One-Design - Manual (Page 5)

INSTALLATION OF RECEIVER BATTERIES
❏
1. Locate the cowl lock button at the rear of the hatch.
Remove the hatch cover by depressing the button in a
twisting motion and then lifting as shown.
❏
2. Remove the four (4) wing nuts and radio box lid
retainers as shown. This will allow you to remove the radio
box cover and access the receiver battery holder.
❏
3. Place four (4) new “AA” batteries into the receiver
battery holder. Be sure to follow the polarity diagram molded
into the battery holder.
❏
4. Replace the battery holder inside the radio box. Make
sure that it will not interfere with any of the control linkages.
❏
5. Replace the radio box cover and radio box lid
retainers. Secure them with the four (4) wing nuts.
INSTALLATION OF TUNED PIPE
❏
1. Remove the tuned pipe, exhaust coupler, tuned pipe
brace, and (2) zip-ties from the accessory box.
❏
2. Slide the exhaust coupler onto the large end of the
tuned pipe and secure it with one of the provided tie-straps.
5