Audio Note M10 Line - Manual (Page 9)

Umbilicals
Two dedicated cables are supplied for connection of the M10 Line
main unit to the Galahad power supply units. Each cable is colour
coded for left and right connection.
IT IS ESSENTIAL THAT THE CORRECT GALAHAD POWER
SUPPLY UNIT IS CONNECTED TO THE CORRECT
CORRESPONDING CHANNEL ON THE MAIN UNIT.
The Galahad power supply units have serial numbers ending with ‘L’
for the left side input and ‘R’ for the right side input.
These serial numbers can be found on the identification badges
located on the rear of each power supply unit .
Make sure you have correctly identified the units before any
connections are made.
The cables are fitted with Military specification circular connectors, and
can only be installed in one direction; the female connector attaches to
the Galahad ‘power out’ socket, the male connector attaches to the
M10 Line main unit ‘power supply input’ socket.
The connectors are a ‘push and twist’ bayonet design, and once the
connector and socket have been aligned, twist the external ring on the
connector to secure it to the socket.
If you are in any way uncertain regarding these connections, please
consult your official Audio Note (UK) agent.
Ground Post Each of the three chassis is fitted with a separate Earth connection /
ground post. The post located on the main preamplifier unit is for
connection to source components that also use a separate ground
terminal. The ground posts located on the Galahad power supplies
can be used in situations where the following amplifiers require a
separate ground connection to maintain quiet, hum free operation.
Please consult your official Audio Note (UK) agent for further
information on how best to use these in your system.
CONNECTION OVERVIEW continued…