Audio Unlimited spk-velo-4kit2 Owners Manual - Manual (Page 3)

P.4
INSTALLATION
TRANSMITTER
1. Connect the supplied AC power adapter to an electrical wall outlet.
2. Plug the AC power adapter (12V/200mA) in the DC jack located on the rear of the
transmitter, or you can insert 4 fresh “AA” size ALKALINE batteries into the
battery compartment of the transmitter with correct polarity. Note: Discharged or
low batteries will result in no signal to the speakers or distorted sound.
3. Turn on the transmitter by set the POWER switch to ON position, the POWER LED
(blue) on transmitter will start flashing.
4. The retractable audio cord that located at the front of transmitter can
be connected to audio output jack of any audio source such as i-Pod, i-Phone,
MP3/CD/VCD/DVD players, smart phone, computer, TV or home theater system.
Home theater systems and other devices with red and white RCA audio
out connections require a 3.5mm female to dual RCA male adapter cable
to connect to the 3.5mm transmitter cable.
P.5
5. The transmitter for this speaker set is designed to work with a wide variety of
devices. Our tests have shown the default volume levels of iPods, MP3 players
and other devices connected to the transmitter through the headphone jack does
not have the signal strength required by the transmitter. Raising the volume of your
device increases the signal strength to the transmitter. The BLUE LED switches
from flashing to steady when the required signal strength from your device is
reached. We recommend that you keep the volume set on your iPod or MP3 player
at a minimum of 75% of full volume.