Cub Cadet CCBT - Manual (Page 7)

7
CLEANING
Use a small brush to clean off the outside of the unit. Do not
use strong detergents. Household cleaners that contain
aromatic oils such as pine and lemon, and solvents such as
kerosene, can damage plastic housing or handle. Wipe off any
moisture with a soft cloth. Also keep the air vents free of
obstructions.
STORAGE
• Allow the unit to cool before storing.
• Lock the unit to prevent unauthorized use or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
To Use the Hanger
To use the hanger, make sure that the attachment is removed from
the unit.
1. Place the hanger on the end of the attachment and slide
down until it touches the release button (Fig. 10).
2. Press the release button and hold it in.
3. Slide the hanger over the depressed release button.
4. Adjust the hanger so that the release button clicks into the
any of the holes in the hanger.
Drive Shaft............................................................................................................................................................................................Steel
Unit Weight.................................................................................................................................................................4 lbs. 15 oz. (2.24 kg)
Cutting Mechanism .......................................................................................................................................................... Fixed Line Head
Line Type................................................................................................................................................. .105 inch (2.667 mm) Spiral Line
Cutting Swath ...................................................................................................................................................................16 inches (40.64 mm)
TROUBLESHOOTING
SPECIFICATIONS
C A U S E A C T I O N
Cutting attachment bound with grass Stop the unit and clean cutting attachment
Cutting attachment line is broken or too short Refill with new line
Shift lever is in blower mode Move the shift lever to trim mode
CUTTING ATTACHMENT WILL NOT CUT
DRIVE SHAFT AND CUTTING HEAD
MAINTENANCE & REPAIR INSTRUCTIONS
TRANSPORTING
• Allow the unit to cool before transporting.
• Secure the unit while transporting.
ACCESSORIES/REPLACEMENT PARTS
Replacement line can be purchased from Cub Cadet dealers:
.105-inch Spiral Line . . . . . . . . . . . . . . . . . . . . . .49UFSHLK953
NOTE: For repairs beyond the minor adjustments listed above, call 1-877-282-8684 if in the United States or 1-800-668-1238 if in
Canada to obtain a list of qualified service dealers.
Release
Button
Hanger
Holes
Fig. 10