Avlink HX-331616 User Manual
Page 11
Matrix Switcher Series—User Manual
10
EDID: FIX (fix mode) and OUT1 (access the first output channel) selection key.
- FIX
mode: The Matrix Switcher supplies a set of fixed EDID values to support up
to only 1080P high performance TV.
- OUT1
mode: The Matrix Switcher will access the EDID values of high
performance TV that connected to the first output channel, and copy the EDID
value to all the input channels so that the DVD player can support to all the
HDTV.
RETURN: Press this key to go back to main screen.
PLUG: Press this key to show you the status of all HDMI Type A jacks on the rear
panel. If the HDMI jack is in HPD (hot plug detect), it will appear “O” on the screen.
Alternatively, it will appear “X” specified the HDMI jack is unused.
INFO: Press this key to show you the Matrix Switcher’s version, ID and IP address.
) Press PLUG and INFO keys simultaneously to show you the firmware versions of
modules.
STO: The “Store Key” saves all current output/input corresponding relations up to 8
sets for a memory control.
- Press the “STO” key firstly.
- Arrange memory location. (Support up to 8 sets of memories, user can select
the memory location through OUT1~OUT8/IN1~IN8.)
- The relations among all settings will be saved in the memory permanently.
RCL: The “Retriever Key” retrieves all settings that are saved in the memory.
- Press the “RCL” key firstly.
- Then make a random to select one of output/input channel key 1~8.
- The system will retrieve the saved all status and implement current status
switching if the previously saving channel is selected.
) Press and hold STO and RCL keys simultaneously at least 1 sec. to restore to factory
default values.
ACTIVE LED: A clear LED indicator designed for reaction by pressing keys on the front
panel and remote controller. Refer to
Appendix A Matrix Switcher Remote Controller.
IR Receiver: Infrared receiver can receive signals from the Matrix Switcher Remote
Controller.
LCD: LCD display shows current Matrix Switcher status and operation status.
) Press any keys on the front panel or controller to enable the light of LCD momentarily.
This function cannot be controlled by RS-232 or LAN.