Avlink YX-1044 - Manual (Page 20)

20
Figure 7-4（a）
Figure 7-4（a） Figure 7-4（b）
Function Description:
Linking Methods: In “Port number” select either COM1 port or COM2 port as shown in
Figure 7-4（b）; in “Baud rate” select 9600 for signal transmission as shown in Figure 7-4（a）
7.0.12 Exit Function Usage
Function Description: To exit the operating software.
7.0.12 Other Usages
Displays the presently saved switching status as shown in Figure 7-5 below:
Figure 7-5
When Video/Audio corresponding to Output is open, it shows the Output ports
corresponds to the Video/Audio Input ports; when they are close the word None will be shown in
red in the above table.
8.0 Communication Protocol and Control Command Code
Communication Protocol: Baud rate 9600bps, no odd or even calibration bit address, 8bit
transmission address, 1bit stop address.
Refer to the “Command list.pdf” on the CD-ROM for the command system.