Avlink HDMI-E8 - Manual (Page 68)

Distribution Amplifier (DA)—User Manual
67
IR Receiver Cable Directions
Put IR Receiver Cable into the HDMI Extender (HX-RW) “IR2 IN” port and place the IR
Receiver Cable, so that you can point to it easily with your IR remote controller.
IR Receiver Cable:
GND
+V
Sig
IR Blaster Cable Directions
Plug IR Blaster Cable into HDMI Extender (HX-RW) “IR OUT” port located on the
front-panel.
IR Blaster Cable:
NC
P+
N-
HDMI Output Connector
Pin # Signal Pin # Signal
1
TMDS Data 2+
11 TMDS Clock Shield
2
TMDS Data 2 Shield
12 TMDS Clock -
3
TMDS Data 2-
13 CEC
4
TMDS Data 1+
14 Utility (NC on device)
5
TMDS Data 1 Shield
15 DDC SCL
6
TMDS Data 1-
16 DDC SDA
7
TMDS Data 0+
17 DDC/CEC Ground
8
TMDS Data 0 Shield
18 +5 Power
9
TMDS Data 0-
19 Hot Plug Detect
10 TMDS Clock+