Awntech DallasRetro CR33-NV - Manual (Page 3)

The Dallas Retro Frame must be installed on the wall as there is no
connecting part between BP and TB
STEP 1: Separate all of the parts by part number so they will be easy to
assemble.
STEP 2: The Top Bar (TB) must be installed first. The C-Channel on the TB
must be close to the wall. Before installing the TB you must make sure that there
is enough space below the TB for the height of the awning. Example R22 style
will need 31” of the space for the height of the awning (please see the chart
below for the height measurements).
*** all the sizes are in inches
Model
Space
between
TB and
BP in
inches
Height
incl.
valance Projection Model
Space
between
TB and
BP in
inches
Height
incl. no
valance Projection
RR22 24 31 24 RR22-NV 24 24 24
CR32 36 44 24 CR32-NV 36 36 24
CR33 36 44 36 CR33-NV 36 36 36
CR34 36 44 48 CR34-NV 36 36 48
CR43 48 56 36 CR43-NV 48 48 36
CR44 48 56 48 CR44-NV 48 48 48
ER2442 18 24 42 ER2442-NV 24 24 42
ER12 8 12 24 ER12-NV 12 12 24
ER1836 12 18 36 ER1836-NV 18 18 36
ER1230 8 12 30 ER1230-NV 12 12 30
ER1030 10 16 30 ER1030-NV 16 16 30
ER23 18 24 36 ER23-NV 24 24 36
ER24 18 24 48 ER24-NV 24 24 48
STEP 3: Install Black Projection Bars (BP). The space between the top of the (TB) and
the Bottom of the (BP) must be according the chart above.
STEP 4: Insert the L shaped plastic ends of the Front Bar (FB) in to Left and Right (BP)
and then secure them with self tapping screws. The Velcro on the (FB) must face up.
STEP 5: Install the NC (left and right) with arrows facing upwards. The holes on the
(FB) and (FB) are pre drilled. Make sure that the Velcro on (NC) facing left and right
STEP 6: If the awning is larger then 4’ (52.5”) wide then you must install additional
(NC)s and (BP)s to complete the frame assembly and installation
STEP 7: Once the frame is completely installed then secure all the joints where
connectors are attached by driving one self tapping screw from inside the frame.
INSTALLING THE COVER
STEP 8: Slide the tubing at the top of the fabric cover into the C-Channel at the top of
(TB).
STEP 9: Pull the remainder of fabric over the frame with the valance hanging down
below the (NC) and (FB) bars.