AXEON DT-Series - Manual (Page 7)

DT – Series User’s Manual
MKTF-208
3. Be certain that all of the components of the feed water are soluble at the
concentrations attained in the system.
NOTE: FEED LINE MUST BE
PERMEATE (PRODUCT WATER) CONNECTION
Locate the 1” connection labeled permeate and attach to storage tank
permeate water can flow freely
irreversible damage to the membrane elements.
holding tank with PVC fittings, or other FDA approved materials
being used does not dissolve into the permeate water.
CAUTION THE PH OF THE REVERSE O
TYPICALLY BE 1-2 POINTS LOWER THAN THE FEED WATER PH. A LOW PH CAN
BE VERY AGGRESSIVE TO SOME PLUMBING MATERIALS SUCH AS COPPER
PIPING.
CONCENTRATE (WASTE WATER) CONNECTION
Locate the 1” connection labeled
line to an open drain in a free and unrestricted manner (no backpressure).
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN
CAUSE BACKPRESSURE, WHICH WILL INCREASE THE
PRESSURE. THIS CAN RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND
COMPONENTS.
ELECTRICAL
The motor used on the DT-
motor is available in 220/380/460 Volt,
system is equipped with a 5 foot electrical cord
Ensure that the electrical circuit supplying the system is compatible with the
requirements of the specific D
7
Be certain that all of the components of the feed water are soluble at the
ttained in the system.
NOTE: FEED LINE MUST BE MINIMUM 1” INCH.
PERMEATE (PRODUCT WATER) CONNECTION
labeled permeate and attach to storage tank
permeate water can flow freely with no backpressure. Backpressure can cause
damage to the membrane elements. The 1” permeate line
with PVC fittings, or other FDA approved materials. This is so the material
ssolve into the permeate water.
THE PH OF THE REVERSE OSMOSIS PERMEATE WATER WILL
2 POINTS LOWER THAN THE FEED WATER PH. A LOW PH CAN
BE VERY AGGRESSIVE TO SOME PLUMBING MATERIALS SUCH AS COPPER
CONCENTRATE (WASTE WATER) CONNECTION
labeled concentrate and attach to a drain. Run
to an open drain in a free and unrestricted manner (no backpressure).
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN
CAUSE BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING
PRESSURE. THIS CAN RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND
-Series systems are a pump and motor combination
/380/460 Volt, 50/60 Hertz, 1 Phase/3 phase
system is equipped with a 5 foot electrical cord.
nsure that the electrical circuit supplying the system is compatible with the
uirements of the specific DT model you are installing.
06/12
Be certain that all of the components of the feed water are soluble at the
labeled permeate and attach to storage tank. Ensure that the
Backpressure can cause
” permeate line can be run to the
This is so the material
SMOSIS PERMEATE WATER WILL
2 POINTS LOWER THAN THE FEED WATER PH. A LOW PH CAN
BE VERY AGGRESSIVE TO SOME PLUMBING MATERIALS SUCH AS COPPER
drain. Run the concentrate
to an open drain in a free and unrestricted manner (no backpressure).
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN
SYSTEM’S OPERATING
PRESSURE. THIS CAN RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND
pump and motor combination. The
phase. Each DT-Series
nsure that the electrical circuit supplying the system is compatible with the