Cres Cor RO151FUA18B-Q1 - Manual (Page 6)

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Ovens with
Microprocessor controls
FL-2269
Rev. 8 (10/06) Page 6 of 13
OPERATING INSTRUCTIONS (continued)
BEFORE CLEANING CABINET:
1. Unplug cord from wall. Allow cabinet to
cool.
2. Do NOT hose cabinet with water.
3. Do NOT get water on controls.
4. Do NOT use abrasives or harsh chemicals.
Hints:
Use the mildest cleaning procedure that will do the job.
Always rub in the direction of the polish lines to avoid
scratching the surface.
Use only a soft cloth, sponge, fi brous brushes, plastic
or stainless steel pad for cleaning and scouring.
Rinse thoroughly with fresh water after every cleaning
operation.
Always wipe dry to avoid water marks.
1.
2.
3.
4.
5.
HOW TO CLEAN THE UNIT:
SOIL CLEANER METHOD
CABINET
Inside and Outside
(Stainless Steel)
ROUTINE CLEANING
Soap, ammonia or mild
detergent* and water. 1. Sponge on with cloth
2. Rinse
STUBBORN SPOTS,
STAINS Mild abrasive made for
Stainless Steel. 1. Apply with damp sponge or cloth.
2. Rub lightly.
BURNT ON FOODS OR
GREASE Chemical oven cleaner
made for Stainless Steel. Follow oven cleaner manufacturer’s
directions.
HARD WATER SPOTS &
SCALE
Vinegar
1. Swab or wipe with cloth.
2. Rinse and dry.
* Mild detergents include soaps and non-abrasive cleaners
Wipe up spills as soon as possible.
Clean regularly to avoid heavy dirt build-up.
MAINTENANCE INSTRUCTIONS
TROUBLE-SHOOTING GUIDE
IF UNIT GETS TOO HOT OR WON’T SHUT OFF, DISCONNECT
POWER AT BRANCH PANEL. DO NOT UNPLUG CORD!
1. Cord is unplugged from wall outlet.
2. Circuit breaker/fuse to wall outlet is blown.
3. Switch is turned off.
4. Thermostat is turned off, or is set too low.
If hot unit is NOT working, fi rst check the following causes: