Operation – Behlen 80110710ORG User Manual
Page 6
•
Do NOT allow anyone to stand between the
hitch and blade.
•
It is only recommended that tractors with wide
front axles use the Grader Blade. Tricycle front
wheel arrangements are inherently unstable
and can cause rollover accidents.
•
Check the tractor master shield over the PTO
stub shaft. Make sure it is in good condition
and fastened securely to the tractor.
•
Make sure all safety stickers are installed and
in good condition. Replace if damaged.
•
Do NOT allow riders. There is no safe place
for anyone to ride or sit on tractor or
implement.
•
Check that all equipment is properly installed
and securely attached to the tractor.
Operation
If you have any questions regarding the
proper operation of this Grader Blade,
contact your dealer or the manufacturer.
The Grader Blade is designed for a wide range
of applications: casting, side ditching, leveling,
terracing, bulldozing and snow removal. The
blade may be angled to windrow debris to the
side for removal. It is the responsibility of the
operator to see that no one else is within
twenty-five feet (25’) of the tractor when it is
started.
•
Set tractor blades.
•
Take tractor out of gear. Shift to “Park” (if
applicable).
•
Grader Blade should be level when operating.
•
Adjust top link so implement is flat on level
surface.
•
Before operation make sure all adjustments
have been made to the blade for desired
operation.
•
Lower blade to ground and start moving
forward. Your speed will be determined by the
condition of the soil. You may need to use
less or more angle depending on the job.
•
Speed of the tractor should not exceed 5
mph.
•
When you are turning, lift the unit from the
ground.
•
Pass diagonally through sharp dips and avoid
sharp drops to prevent “hanging up” the
tractor and blade.
•
Watch for hidden hazards on the terrain
during operation.
DO NOT TAKE A DITCH AT 90° (straight on)!
Always go in at an angle or damage may
occur.
Before dismounting power unit or performing
any adjustments to the Grader Blade, make
sure to disengage power to equipment, lower
3-Point hitch and all raised components to
the ground, operate valve levers to release
any hydraulic pressure, set parking break,
stop engine, remove key and allow implement
to come to a complete stop before
dismounting tractor. Never leave equipment
unattended with tractor running.
It is essential that everyone involved in the
operation, transportation, maintenance, and
storage of this equipment be aware,
concerned, prudent and properly trained in
safety.
The moldboard blade is sharp. Exercise
extreme caution when working around or near
the blade. Failure to stay clear of the blade
can result in serious injury.
Stop power unit and equipment
IMMEDIATELY upon striking an obstruction.
Turn off engine, remove key, inspect, and
repair any damage before resuming
operation. Never leave the seat of the tractor
while engine is engaged.
OPERATION & MAINTENANCE INSTRUCTIONS
DANGER
CAUTION
DANGER
F-20833
1-10-11
CAUTION