Canon BCI-21 - Manual

1
Http://www.usaink.com
REFILL INSTRUCTIONS FOR ALL CANON CARTRIDGES
BLACK AND COLOR
TABLE OF CONTENTS
INTRO.......................................................1
BCI-21 & BCI-24 BLACK............................... 2
BCI-21 & BCI-24 COLOR ..................................3
PG-40 BLACK..........................4
CL-41 COLOR .......................5
BCI-3, BCI-5, BCI-6 BLACK...............6
BCI-3, BCI-5, BCI-6 COLOR ................same page...6
PGI 5BK & CLI 8 COLOR
...........
7
CONTACT AND RE-ORDER INFO ..................8
TROUBLESHOOTING.................................................9
PERFORM ALL OF THE FOLLOWING STEPS OVER THE SINK
HELPFUL HINTS TO REMEMBER AS REFILLING
IN REGARDS TO THE SYRINGE PROVIDED:
RINSE OUT THE SYRINGE AFTER EACH COLOR ......... ESPECIALLY THE BLACK.
SHOOT OUT ALL WATER BEFORE DRAWING UP NEW COLOR.
INSIDE OF THE SYRINGE DOES
NOT HAVE TO BE “BONE DRY.”
Your bottles of ink will have electrical tape on the caps when you
receive them. One little trick is to not remove the cap but melt a little
hole into the top using the end of a heated paperclip.
Melt the hole, “Off center.”
SEE FIGURE > > > > > >
By doing this, all you have to do is stick the needle thru
the hole and
tilt the bottle a little to draw up the ink. When done, you can place a
piece of tape over the hole till next time.
1