Bike2Power SpinPower - Manual (Page 4)

ENGLISH
4 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Incorrect installation of the dynamo may cause it to fall between the wheel spokes and jam the
wheel. Always ensure that your dynamo is secure before and after the ride, and every few miles
during the longer rides.
Incorrect installation of the dynamo may cause an increase in the wear of the bicycle tire. If
you are not sure how to install the dynamo, consult or hire a professional installer.
The kits are water resistant, but not waterproof. Avoid submerging in water or using in rain or
snow without a protective cover. If a kit becomes wet, remove the kit from the bicycle and allow
it to dry out before reinstalling and using again.
The connectors of this device may contain a small amount of nickel. Persons sensitive to nickel
may experience symptom from the prolonged skin contact with the connectors.
The kits may contain small parts which may constitute choking hazard. Keep them out of reach
of small children.
Read the installation instructions carefully. Do not attempt to substitute any parts of the kits.
Use the kits only with the compatible mobile devices. Never force the connectors into ports.
Make sure that the connectors match a port and that you have positioned them correctly.
Never force the groves into the slots. Make sure that the groves match the slots and that you
have positioned them correctly.
These kits are not suitable for rough terrains, off-road, or trick bicycling.
The kits may be affected by extreme temperatures. Always keep the kits between -15◦ C (5 F)
and +55◦ C (131 F).
Bike2Power is not responsible for any damages or failure to the devices charged using the
SpinPower Kits. Bike2Power is not responsible for any damages or failures caused to the
bicycle used to mount the SpinPower Kits.
Compatible Devices
SpinPower Bicycle Phone Charger Kits are compatible with 5v devices able to charge through
USB.
SpinPower S1 is compatible with the major smartphone makes and models as well as Android®
phones. SpinPower I3 is compatible with the iPhone® 3G/3GS and some older iPhone models.
SpinPower I4 is compatible with the iPhone® 4/4S.
Parts and Technical Specifications
Parts*
SpinPower Bicycle-mounted Phone Charger Kits contain:
A. Dynamo Mounting Bracket
B. Dynamo
C. Holder Bracket with Charger
D. Phone Holder
*Product colors and accessories are subject to change without notice