Blinds Chalet Aspen 1 Faux Wood Blinds - Manual (Page 2)

Basswood & Fauxwood Blind
Installation Instructions
Attach the loose plastic valance clips (Part 1) to the front of the headrail,
one at each end. Space any remaining clips evenly. Press the other side
of the plastic clip (Part 2), which is already screwed to the valance, to
Part 1. The two parts of the valance clip should snap together. Align the headrail with the center support and box brackets. The
headrail should have the tilt mechanism facing toward the room.
Be careful not to trap the top slat in the brackets and slide the
headrail straight back until it is snug in the brackets. If the headrail
can slide from side to side in the box brackets, you can use a flat
head screwdriver to bend out the tabs on the end of the until it is
snug.
Lower the
front gate of each box bracket
and press until the locking tab
clicks into place.
(For Outside Mount Installations)
(For Inside Mount Installations)
Screw brackets in window frame as shown.
With the hold-down brackets attached to the bottom rail, lower the blind
to the hold down bracket mounting surface
and mark the bracket locations. Attach the
hold down brackets at the bottom of the
window or door with the included screws
as shown. To attach the bottomrail, gently
pull the brackets out slightly, and insert the
pins into the holes on the bottomrail of the
blinds.
To lower the blind, pull the cord down and towards the center of the shade to unlock the cord. Then, slowly release the cord until the shade reaches the
desired location. Move the cord past the outer edge of the shade and let go to lock the cord.
To raise the blind, pull the cord straight down until the shade reaches the desired location. Move the cord past the outer edge of the shade and let go to
lock the cord.
Step 6: Blind Installation Step 5: Valance Installation
Step 4: Bracket Installation
Operating Instructions:
Valance shown with the side
return
Step 7: Safety Cleat Installation
Find a convenient place about 1” out from the side of the
shade where the pull cords are located and about one quarter
of the way up from the bottom of the shade. Hold the cord
safety cleat parallel with the window frame. With a pencil,
make a mark through the holes. Screw the cord safety clip to
the wall.
To avoid strangulation and entanglement keep
all cords out of reach of children by installing
safety cleats that limit access to the cord and /or
chain.
Step 8: Attach Hold Down Brackets
(Optional—Typically used for door installations)
Step 1 Step 2