Blinds Chalet EcoGreen Solar Screen Shades - Manual (Page 4)

4.
2) Install the Shade
Push the clutch straight onto the blade of its bracket. The bottom of the clutch should
always point straight down, as shown in the illustration on page 3. Lower the lug of the
end plug onto the V of its bracket. The roller should fit in the brackets securely, with just a
little play.
ATTACH FASCIA PANEL
Attach the fascia by first hooking the top lip of the fascia
panel onto the bracket as shown. Swing the bottom of the
fascia panel towards the bracket and gently press at the
bottom of the panel until the lip on the fascia engages and
snaps lock to the bracket.
3) Attach Stops to Metal or Plastic Bead Chain
For plastic bead chain, use connector for top stop and attach another connector for lower
stop. For metal bead chain, attach a metal stop ball at least 5/16” (8 mm) in diameter so
that it touches the clutch when the shade is rolled all the way up. For both kinds of bead
chain, lower the shade to sill or floor height, and snap the appropriate metal stop or plastic
connector on the opposite side from the stop, so that the shade cannot be lowered
beyond that point.
4) Install the Tension Device
The tension device reduces the hazards of strangulation and entanglement of
young children and pets by limiting access to the control cord. Anchor the
tension device that is attached to the shades control cord or bead chain to
the window frame or wall so that young children or pets cannot pull the cord
or bead chain around their necks.
a. Lower the shade.
b. Hold the tension device upright so the warning tag hangs straight down as
shown in diagram.
c. Position the tension device on the window frame or the wall so that the
tension device and control cord do not interfere with raising or lowering the shade.
The tension device should be installed without stretching or pulling down on the
control cord. Stretching the cord will cause excessive wear. Do not twist or cross
the control cord. If using stop balls on bead chain, position the tension device
1/4” higher to allow the stop ball to pass thru the tension device.
d. Holding the tension device upright, and in position, as shown, insert and secure the
screw through the hole. The mounting screw must be secured into a solid surface or
molly.
5) Use the Control Cord or Bead Chain to Operate the Shade
Pulling gently on one side of the control cord or bead chain raises the shade; pulling down
on the other side lowers it
.
K2111-REV0407 April 2007
part number: AL362000.
part number: AL362000.