Chauvet Q-WASH 260-LED - Manual (Page 13)

Operation
Q-Wash 260-LED User Manual Rev. 05 -9-
4. Operation
Control Panel
Description
Button Function
<MENU> Exits from the current menu or function
<ENTER>
Enables the currently displayed menu or sets the currently selected value
in to the current function
<UP>
Navigates upwards through the menu list and increases the numeric value
when in a function
<DOWN>
Navigates downwards through the menu list and decreases the numeric
value when in a function
Control Options You can set the Q-Wash 260-LED start address in the 001~512 DMX range. This allows
for the control of up to 39 products in the 13-channel ADVANCED personality.
Programming Refer to the Menu Map on page 15 to learn how the menu options relate to each other.
The menu map has a Menu Level and a variable number of programming levels for each
option.
To go to an option in the Menu Level, press <MENU> repeatedly until the option shows on
the display. Press <ENTER> to select it. This will take you to the first programming level for
that option.
To select an option or value within the current programming level press <UP> or <DOWN>
until it shows on the display. Press <ENTER> to accept. In this case, if there is another
programming level, you will see its first option. Otherwise, you will see the selected value.
To exit to the previous menu level, press <MENU>.
In the EDIT menu, <UP> and <DOWN> will only change the value of the current
option. To change to the next option, press <ENTER>.
DMX Operation 1. Select DMX operation.
a) Go to MENU > INTRO > RUN.
b) Select DMX512.
2. Select a DMX mode.
a) Go to MENU > INTRO > CHANNELS.
b) Select BASIC or ADVANCED.
3. Select the starting address.
a) Go to MENU > INTRO > ADDRESS.
b) Select a starting address, 001~500 (Advanced) or 001~504 (Basic).
The highest possible starting address for each DMX mode is as follows:
DMX Mode DMX Address
Basic 504
Advanced 500
Stand-alone
Operation
1. Go to MENU > INTRO > RUN.
2. Select a stand-alone operation mode (AUTO 1, AUTO 2, CUSTOM, or
TEST).
Of all the stand-alone operation modes indicated above, only “CUSTOM” is editable
(see Edit Custom).