Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 25)

Using the Registers
Labeling or Re-naming a Register:
If you are not in REG mode, press Reg. You will be taken to the last storage location
viewed or accessed and its current name will be displayed. Or, to find a particular
register, use the adjust knob and or cursor keys to locate the one you are looking for.
Having located the one you want to change, press Enter to load it, then press Reg again
and you can label the name as previously described. Press Enter when you are finished
to save the new name.
Note: Editing the register name/label is a separate function from saving and affects only
the name, not the parameters.
Recalling a Register:
Press Reg. You will be taken to the last location you viewed or accessed. If you wish to
choose a different register, turn the adjust knob to find a suitable program that you
previously stored. The cursor keys will jump you through the 50 user registers by groups
of 10, the adjust knob scrolls one by one. After finding one, press Enter and the program
will be loaded. As with selecting programs, the * will appear when you are viewing a
register that is not the current running one, or if you are running a program loaded from
the PROG menu. Pressing Reg again will take you to the current running register
program.
Protecting a Register Bank:
You can protect a register bank from being written to. Press System, and push the cursor
keys and find “Lock Reg Bank”.
Turn the adjust knob to select the bank you want to protect and press Enter. This will
lock the bank and an “L” will be displayed to show the bank is locked.
EDIT
L o c k R e g B a n k
B a n k 0 L
Value Parameter selects parameter Adjusts value
ENTER
Sets value
Un-Protecting a Register Bank:
To unlock a bank turn the adjust knob to select the bank you want to unprotect and press
Enter. The “L” character will disappear to now show the bank is unlocked.
EDIT
U n l o c k R e g B a n k
B a n k 0
Value Parameter selects parameter Adjusts value
ENTER
Sets value
2-6