Buick 2005 Rendezvous - Manual (Page 128)

Erasing HomeLink ® Buttons
To erase programming from the three buttons do the
following:
1. Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
Do not hold the two outside buttons for longer
than 30 seconds.
2. Release both buttons.
HomeLink ® is now in the train (learning) mode and can
be programmed at any time beginning with Step 2 under
“Programming HomeLink
® ” shown earlier in this section.
Individual buttons cannot be erased, but they can be
reprogrammed. See “Reprogramming a Single
HomeLink
® Button” following this section.
Reprogramming a Single HomeLink ®
Button
To program a device to HomeLink ® using a HomeLink ®
button previously trained, follow these steps:
1. Press and hold the desired HomeLink ® button. Do
not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink ®
button, proceed with Step 2 under “Programming
HomeLink
® ” shown earlier in this section.
Resetting Defaults
To reset HomeLink ® to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink ®
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink ® at
1-800-355-3515, or on the internet at
www.homelink.com.
Storage Areas
Glove Box
If the glove box has a lock, put your key into the lock
and turn the key counterclockwise. To open the
glove box, pull the latch release.
The glove box door has a detent to prevent the door
from lowering too far. Open the glove box until the door
is partway open, then pull the door down if you need
it fully opened.
To close the glove box, the door must be pushed up
past the detent. To lock the glove box, put your key into
the lock and turn the key clockwise.
2-38