Carl Goldberg GBGA1069 - Manual (Page 16)

16.
!
Thread the snap-links onto each of the wires,
until the the wire shows in the middle of the
snap-link.
17.
!
Connect the snap-link to the second hole of
control horn.
18.
!
While keeping the elevator level with the
stab, mark where the pushrod wire meets the
servo arm hole.
!
Bend the the pushrod up and cut off the end
of the wire leaving 1/2” up.
!
Slide the snap-r-keeper towards the servo
and snap onto the wire and around the servo
arm.
15.
!
Once the wire has exited the fuselage,
remove the nylon tubing from the end of the
wires.
Motor Mount/Engine Installation
2.
!
Using the alignment marks, center the motor
mount on the firewall and tack glue.
REMEMBER, the following pictures and instruc-
tions may vary slightly, depending on the equipment
you are using.
1 Collect the following items:
(1) Engine
(1) Motor Mount
(4) 6-32 x 1-1/2” socket head screw
(4) 6-32 Blind nut
(4) #6 Washer
(4) #8 x 1” Pan head screw
(3) 1/4” x 2-3/4” Plywood spacer
ALIGN
MARKS
ALIGN
MARKS
16