Carl Goldberg GPMA1956 Eagle 2 ARF - Manual (Page 23)

23
1. Collect the following items::
(1) ½ x 8 x 12" foam rubber (Not Included)
(1) Assembled fuel tank
(1) 10" length of fuel tubing
CAUTION! The white neprene stopper and the fuel
tubing provided with this kit are FOR GLOW FUEL
ONLY; DO NOT USE THESE PARTS FOR GASO-
LINE.
2.
Insert both brass tubes through the wide end of the
rubber stopper. Leave 1/2” extending out the front
of the tank.
Place the small nylon washer on both tubes, as
shown, making sure that one of the tubes extends
1” past the washer. This tube will be for the klunk
pickup.
Cut tube as necessary.
3.
Bend the other tube, at the angle shown, until it
nearly reaches to the fuel tank wall. This is the
vent/overflow tube.
4.
Insert the stopper assembly into the fuel tank until
the vent tube is up inside the “bubble” in the fuel
tank wall. Remove the assembly and trim the vent
tube, if necessary.
5.
Install the klunk on the white fuel tubing.
Mount the other end of the fuel tubing onto the brass
outlet tube in the stopper.
6.
Again place the stopper assembly into the fuel tank.
If the klunk is touching the back wall of the tank, trim
it as needed.
7.
Place the large nylon cap onto the two brass tubes.
When satisfied with the fit of the entire stopper
assembly, tighten the #4 x 1” screw into the center
of the stopper. Take care to not over-tighten the
screw.
FUEL TANK INSTALLATION