Carl Goldberg GPMA0955 EAGLE 2 - Manual (Page 32)

31
13a. From the threaded end of two 10" rods, measure and
cut one of the rods to 7" and the other rod to 4½".
13b. At cut end of rods, bend down about 1/4" making a
square hook.
13c. Using the threaded end of a rod, file a slight recess 1"
long at one end of each 5/16" square x 24" balsa push-
rod .
Drill a 1/16" diameter hole 1/4" deep at end of recess in
both pushrods.
Glue rods into balsa pushrods as shown.
When dry, taper ends of pushrods and round off cor-
ners, Bind with strong thread, coat with glue and let dry.
The other end of the pushrods is completed later during
radio installation .
THIS COMPLETES THE FUSELAGE ASSEMBLY