Carl Goldberg GBGA1072 - Manual (Page 6)

Mark the top of the fuselage
where the leading edge of the stab is
located. Now turn the fuselage over
and mark the stab along the fuselage
sides.
Remove the stab from the
fuselage and very carefully with a
#11 Xacto blade remove the
covering between the lines. By
removing the covering you are
gluing to the wood and not the
covering, giving you a much stronger
joint. Cut about 1/16” inside the
lines. Be careful not to cut the wood.
Now carefully remove the
covering at the rear of the fuselage.
Be careful not to remove the
covering too far in front of the stab.
Mix a small amount of 30 -
minute epoxy and spread a thin coat
on the exposed area of the stabilizer.
Carefully place the stab on the
fuselage and again tape in place.
Make sure it is square with the
fuselage and level with the wing
saddle. Set aside until the epoxy is
dry.
6