Carl Goldberg GBGA0059 User Manual
Page 20
20
29. Position the 1/16" D/C plywood yoke snugly
under the hatch pin and glue in place.
30 Trim the plastic cockpit detail to fit onto the plat-
form.
Glue the plastic detail in place and trim any
excess flush with the platform edges.
31. Apply the instrument panel decal (see decal
instructions in Final Assembly section.)
Fit the canopy in place, rough trimming it to
size.
Making sure the platform remains flat, glue the
canopy to the platform.
Trim excess plastic flush with the platform bot-
tom and front. Trial fit the back of the canopy
onto the wing. The final fitting will occur when
the wing is mounted on the fuse.
32. Glue the two 1/16" D/C plywood tow hook
mounting plates together.
Fit the laminated mount in place, as shown on
the plan.
33. With the punch marks facing up, drill a 3/32"
diameter hole through the plywood mount and
the balsa fuse bottom.
Trace the tow hook washer on the fuse bottom
and cut in the washer clearance, as shown. Be
sure to go through the balsa and down to the
plywood layer.