CHEVROLET 2011 Corvette - Manual (Page 38)

Black plate (6,1) Chevrolet Corvette Owner Manual - 2011
2-6 Keys, Doors and Windows
9. To program additional
transmitters, repeat Step 7.
Press Acc. on the ignition switch
if programming is complete.
10. Press
K
on each newly
programmed transmitter to
complete the process.
Programming without a
Recognized Transmitter
This procedure requires three
10-minute cycles to complete the
programming process. United
States owners are permitted to
program a new transmitter to
their vehicle when a recognized
transmitter is not available. The
Canadian immobilizer standard
requires that Canadian owners see
their dealer for programming new
transmitters when two recognized
transmitters are not available.
1. The vehicle must be off.
2. Place the new transmitter in
the glove box transmitter pocket
with the buttons facing the
passenger side.
3. Insert the vehicle key into the
key cylinder located above the
license plate.
4. Open the hatch/trunk.
5. Turn the key five times within
five seconds.
6. The DIC message displays
OFF-ACCESSORY TO LEARN.
7. Press Acc. on the ignition
switch.
8. The DIC reads WAIT
10 MINUTES and counts down
to zero.
9. The DIC displays
OFF-ACCESSORY TO LEARN
again.
10. Press Acc. on the ignition
switch.
11. Steps 8, 9, and 10 will be
repeated two more times.
12. A beep sounds and the DIC
reads READY FOR FOB #1. All
previously known transmitter
programming has been erased.
13. A beep sounds once
programming in complete.
The DIC displays READY
FOR FOB #2.