Surface burners, Before putting the burners back, dry – Whirlpool FGP320A User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
C A R I N G F O R Y O U R R A N G E
Surface burners
1. Lift up the cooktop, following the instruc
tions above.
2. Before cleaning, remove screws that
hold each of the burners in place. The
screws prevent the burners from moving
during shipment. Remove the shipping
screws with a Phillips screwdriver, lift the
burner up, tilt it to one side at the end
closest to the ignitor and move it toward
the back of the range. This separates the
burner from the gas valve at the front of
the range, so it can be easily removed.
3. Wipe off surface burners with warm,
soapy water and a sponge after each use.
To remove cooked-on food, soak the
burners in a vinegar and water solution for
20-30 minutes. Scrub with a plastic
scrubbing pad.
4. If ports are clogged, clean with a
straight pin. DO NOT enlarge or distort
the ports. DO NOT use a toothpick to
clean the ports.
5. Before putting the burners back, dry
them thoroughly by setting them in a
warm oven for 30 minutes.
6. Replace burners, making sure they are
properly seated and level. Replace
screws.
7. Occasionally check the burner flames
for proper size and shape as shown. A
good flame is blue in color. If flames lift off
ports, are yellow, or are noisy when
turned off, you may need to clean the
burners (see above), or call a qualified
technician for adjustment.
Screws
Typical surface burner flame
at the highest setting
19