Make sure the drain hose is, Higher than the water level in, The washer. if it isn’t – Whirlpool LT5008XM User Manual
Page 17: If your washer stops during, The permanent press cycle, Dryer doesn't run or, Doesn’t heat, Drying time seems long, Before calling for assistance
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
If you need service or assistance,
we suggest you follow these four steps:
1. Before calling for assistance...
Performance problems often re
sult from little things you con find
and fix yourself without tools of any kind
IF YOUR WASHER DOES NOT FILL:
• Is the power supply cord
plugged in'i’
• Are both water faucets open'’
• Are fuses blown or circuit-breaker
tripped’’
• Are the water supply hoses kinked’’
• Is the Cycle Control Knob set and
pulled out?
IF YOUR WASHER DOES NOT SPIN;
• Is the lid closed?
• Is the power supply cord plugged in?
• Are fuses blown or a circuit-breaker
tripped?
IF WASHER DRAINS AT THE WRONG TIME:
• The drain hose should be at least
28 inches above the floor and
secured.
• The drain hose should not fit tightly
in the drain pipe.
MAKE SURE THE DRAIN HOSE IS
HIGHER THAN THE WATER LEVEL IN
THE WASHER. IF IT ISN’T...
• The washer may seem to be
draining during wash and rinse
cycles.
• Water can siphon out (See "In
stallation Instructions "1
IF YOUR WASHER STOPS DURING
THE PERMANENT PRESS CYCLE;
• Remember, the washer will stop
for about 1'
2
minutes after the
partial drain during the cool
down period in this cycle
DRYER DOESN'T RUN OR
DOESN’T HEAT:
• Is it plugged in’’
• Is the circuit-breaker tripped or
one or both of the fuses blown?
• Did you push START?
• Is the door closed?
• The AIR setting is without heat.
• The last minutes of heat settings
are without heat. See page 12.
DRYING TIME SEEMS LONG:
• Is the lint screen clean?
• Is the room cold?
• Check your"Laundry Guide,"
pdge19.
17