What happens in each cycle – Whirlpool 8LSC6244BG0 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING YOUR WASHER
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer will begin agitating
immediately after filling; agitation can occur
with the washer lid up or down. After agita
tion starts, the Cycle Control Knob turns
clockwise until it points to 0(0*^^) the
cycle ends.
WASH
Fill
The washer pauses briefly throughout
each cycle.
These pauses are normal for
washer operation.
(2 speed models)
NOTE:
A Gentle Wash system helps protect
your fabrics by reducing wash agitation
speed during the last few minutes of wash
agitation in the Regular and Permanent
Press cycles.
Wash selected time
Drain (or partial draint)
No agitation
+ The Permanent Press cycle partially
drains, fills, agitates briefly, and drains.
a
Spin
RINSE
.......
Fill
JÎÎL-
M
Rinse
Drain-No agitation
Spin-Spray rinse
Spin
A
Off
10