Whirlpool RB770PXB - Manual (Page 30)

U S I N G T H E S E L F - C L E A N I N G C Y C L E
If a cleaning cycle other than 3 hours is
desired, use the Hour and Minute pads
to set the desired cleaning time. Push the
“up" (▲) or “down" (T) pad(s) until a time
between 2-4 hours shows on the display.
• Use 2 hours for light soil.
• Use 3-4 hours for moderate to heavy soil.
Push the Start/Enter pad. TIMED and
HEAT will light up on the display to
indicate that the oven is programmed for
the Self-Cleaning cycle.
NOTE: The display will show “door' and a
tone will sound once a minute for 5
minutes if the door is not latched.
4. To delay the start using Stop Time:
Push the Clean pad. Push the Stop Time
pad. STOP. TIME, CLEAN, and “cin" will
light up. Use the Hour and Minute pads to
set the desired stop time. Push the “up"
(A) or “down" (T) pad(s) until the correct
time shows on the display. The oven will
automatically compute the delay start time
by subtracting the set cleaning time from
the set stop time.
Push the Start/Enter pad. DELAY,
CLEAN, and the time of day will light up
on the display to indicate that the oven is
programmed to start the Self-Cleaning
cycle at a later time. Skip to Step 6.
5. To delay the start using Start Time:
Push the Clean pad. Push the Delay Start
Time pad. START, TIME, CLEAN, and
“cIn" will light up. Use the Hour and Minute
pads to set the desired start time. Push
the “up" (A) or “down" (T) pad(s) until the
correct time shows on the display.
Push the Start/Enter pad. DELAY,
CLEAN, and the time of day will light up
on the display to indicate that the oven is
programmed to start the Self-Cleaning
cycle at a later time. After the start time
has been set, the large display will go
back to showing the current time of day.
DELAY and CLEAN will stay on. When the
start time is reached, DELAY will go off,
TIMED, CLEAN, and CLEAN TIME will
light up, and the oven will start to clean.
HOUR MINUTE
DELAY
START
TIME
30