Removing and adjusting the freezer shelves, To remove the shelves, Removing the freezer trivet to remove the trivet – Whirlpool ED20SK User Manual
Page 7: Changing the light buib, To change refrigerator light, Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lift the right side, then slide out.
Removing and adjusting the freezer
shelves
To remove the shelves:
1. Lift right side of shelf off supports.
2. Slide shelf out of shelf support holes.
3. Replace in reverse order.
To adjust the shelves:
1. Remove shelf as above.
2. Remove supports by sliding upward.
3. Replace supports on desired level.
4. Replace shelf.
NOTE: The cup shaped supports go in the back of
the freezer.
Removing the freezer trivet
To remove the trivet:
1. Lift the trivet from the support brackets at rear of
side wall.
2. Replace in reverse order.
Changing the light buib
^WARNING
Electrical Shock Hazard
Before removing a light bulb, either unplug
the refrigerator or disconnect the electricity
leading to the refrigerator at the main power
supply. Failure to do so could result in
electrical shock or personal injury.
To change refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind the control console to find bulb.
3. Remove bulb.
4. Replace with a 40-watt tubular appliance bulb.
5. Reconnect power supply.
NOTE: Not all commercial appliance bulbs will tit
your refrigerator. Be sure to replace bulb with one
of the same size and shape.