Whirlpool AX6245V - Manual (Page 11)

Before you call for service
If you are having an operating problem,
check this chart to see what might be
the cause before you call for assistance.
Operating problem Check if What to do
Washer will not fill. Power cord is plugged into a live circuit with
proper voltage.
Firmly plug power cord into electrical outlet.
Check circuit voltage at fuse/circuit breaker
box.
Fuse has blown or circuit breaker has
tripped. Check if time-delay fuse has been
used.
Replace fuse with a time-delay fuse of the
correct capacity. Reset circuit breaker.
Both hot and cold water faucets are open. Open both faucets.
Water supply hoses are kinked. Straighten hoses.
Cycle control knob is set and pulled out. Set cycle control knob and pull out firmly.
Washer does not spin. Lid is closed. Close lid firmly.
Power cord is plugged into a live circuit with
proper voltage.
Firmly plug power cord into electrical outlet.
Check circuit voltage at fuse/circuit breaker
box.
Fuse has blown or circuit breaker has
tripped. Check if time-delay fuse has been
used.
Replace fuse with a time-delay fuse of the
correct capacity. Reset circuit breaker.
Washer stops during
a cycle.
Washer pauses briefly at different times in
each cycle. These pauses are normal.
Wait a minute to see if washer starts cycle
again.
Power cord is plugged into a live circuit with
proper voltage.
Firmly plug power cord into electrical outlet.
Check circuit voltage at fuse/circuit breaker
box.
Fuse has blown or circuit breaker has
tripped. Check if time-delay fuse has been
used.
Replace fuse with a time-delay fuse of the
correct capacity. Reset circuit breaker.
Washer fills and drains
without miming.
Cycle control knob is pointing to a number in
the cycle.
Set cycle control knob on correct number in the
cycle.
Washer drains during
wash and rinse cycles
or water siphons out.
Drain hose is higher than the water level in
the washer.
Adjust drain hose so that it is higher than the
water level in the washer.
Page 11