Using, Your washer, Set the temperature selector – Whirlpool LA3000XK User Manual
Page 4: Select a cycle and start the washer, Using your washer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using
Your Washer
start your washer after you put in
detergent, the load, and any other
laundry aids according to information
on page 3
1
.
Set the TEMPERATURE SELECTOR,
• Match the wash water temperature to
the type of fabrics and soils being
washed. All rinses are oold
Cold water rinses save energy
and help prevent wrinkles frorn
setting into fabrics.
2
.
Select a Cycle and start the
Washer.
• Push the Cycle Control Knob in and
turn It to the right (olockwise).
• Stop when the pointer is on the num
ber of minutes you want in the cycle you
want,
NOTE:
In the REGULAR HEAVY
and KNIT GENTLE Cycles, the washer wil
fill only if the Control Knob points to a fil
area,
• Instructions on which cycle to use for
each fabric type are under the lid
• To start the washer, pull the Cycle
Control Knob out. When the cycle is
over, the washer will stop
• To stop the washer at any time
during a cycie, push the Controi
Knob in. Pull it out to restart the washer,
• To change a setting, push the Con
trol Knob in to stop the washer. Then
turn the Control Knob to the right (clock
wise] to the setting you want. Pull the
knob out to start the washer.