Casio EX-FC100 - Manual (Page 142)

142
Using the Camera with a Computer
4.
Turn off the camera and then use the USB cable that comes with the
camera to connect it to your Macintosh.
• The camera does not draw power over the USB cable. Check the battery level
before connecting and make sure it is not too low.
• Make sure that you insert the cable connector into the USB/AV port until you
feel it click securely into place. Failure to insert the connector fully can result in
poor communication or malfunction.
• Note that even while the connector is fully inserted, you
still will be able to see the metal part of the connector as
shown in the illustration.
• When connecting the USB cable to a USB port, make
sure you align the connector correctly with the port.
• Your computer may not be able to recognize the camera
if you connect via a USB hub. Always connect directly to the computer’s USB
port.
5.
Turn on the camera.
The camera’s back lamp will light green at this time. In this mode, your Macintosh
recognizes the memory card loaded in the camera (or the camera’s built-in
memory if it does not have a memory card loaded) as a drive. The appearance of
the drive icon depends on the Mac OS version you are using.
USB port
USB cable
Making sure that the 6 mark on the camera is aligned with
the 4 mark of the USB cable connector, connect the cable
to the camera.
USB/AV port
Large connector
Small connector