Whirlpool 3393 137 - Manual (Page 5)

Recessed
and closet
installation
instructions
A WARNING
Fire/Health Hazard
• Exhausi the dryer to the outside
to prevent exposure to
substances in the gas fuels
and combustion which may be
harmful to your health.
• If dryer is insfalled in a closet,
the dryer MUST be exhausted
outside.
Failure to do so may result in
a fire.
^he following installation spacings
and door air openings for the
aompact dryer are possible when
nstalled with or without the Stack
?ack Kit LCK 1100 and exhausted
as noted. (Spacing as indicated is
n inches and is minimum allowable
-or ease of installation and service,
additional spacing should be
aonsidered.)
Recessed
front view
0" 0-
PC't No. 3393137 Rev. B
yvO Wh'MOOOl CC'OC'OT CO
46 —
sq.in*
2.i
sq. in^
I
3"
T
I
3"
Closet
Front view
TO PREVENT LARGE AMOUNTS OF
LINT AND MOISTURE FROM
ACCUMULATING AND TO MAINTAIN
DRYING EFFICIENCY, THIS MACHINE
MUST BE EXHAUSTED OUTDOORS.
‘ Additional clearances for wall, door and floor
irtoldings may be required,
■ ’Opening is minimum for closet door. Louvered
door with equivalent air openings is acceptable.
‘“Additional space is needed when external exhaust
elbow is LEed.
Companion appliance spacings
should be considered.
Detailed space requirements can
be found on the label located on
the back panel of dryer.
NOTE: No other fuel burning
appliance may be installed in
the same closet.
AMiirÎpool
, CORPORATION
If dryer does
not operate
properly...
If dryer will not operate, check the
following to be sure that:
A. Electrical supply is connected.
B. Fuse is intact and tight.
C. Door is closed.
D. Controls are set in a running or
■'ON' position.
E. Start button has been pushed firmly
or the power control lever moved
upward to start.
F. Gas shutoff valves are open both on
dryer and on supply lines.
When moving the dryer...
• Disconnect the electrical cord and
grounding wire and tape securely
to dryer.
. Shut off the gas supply valve controls
in the gas supply line,
. Disconnect gas pipe fittings from
dryer and cap the gas supply line
• Tape the drum to the front panel
Tape the dryer door, int screen lid
and end of gas pipe,
. Screw leveling legs all the way in.
Before installing your dryer in your new
home, check with your gas supplier or
dealer to see that your dryer is
equipped with the correct burner for
the particular type of gas in your new
home. Burner information may be
found on the rating plate in the door
well of the dryer.
O G r > y Ü C O C c r p O ' O Î K