Step 1 - cold water supply fitting, Installation steps – Whirlpool WHED10 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Installation Steps

Step 1 - Cold Water Supply Fitting

Check and comply with local plumbing codes as you plan, then install a cold feed (supply) water fitting.
The fitting must provide a leak-tight connection to the water filter 3/8” tubing. A typical connection

using the included water supply fitting is shown in Figure 2A. An optional connection using standard
plumbing fittings (not included) is shown in Figure 2B.

Cold Water Supply Fitting

1. Close the house main water shutoff valve and open faucets to drain water from the sink cold water

p

i

p

e

.

2. Remove nut that connects the cold water faucet to cold water plumbing.

3. Thread water supply fitting onto pipe and reconnect nut to bottom of fitting.

Optional Pipe Fittings (compression type shown)

NOTE:

Be sure to turn off the water supply and open a faucet to drain the pipe.

Install a fitting on the cold water pipe to adapt 3/8” OD tubing. A typical connection is shown in Figure
2B. If threaded fittings are used, be sure to use pipe joint compound or Teflon tape on outside threads.

A.

Water supply connect! on

B.

Water supply typical connection

(using compression fitting)

Figure 2

Advertising