Removing the ice maker storage bin, Emoving, Maker – Whirlpool ED20TWXDN02 User Manual
Page 20: Storage
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING YOUR REFRIGERATOR
R
emoving
the
ice
maker
storage
bin
There are several reasons why you may need to re
move, empty, and clean the ice maker storage bin.
• The ice dispenser has not, or will not, be used for
a week or more.
• A power failure causes the ice in the bin to melt
and freeze together.
• The ice dispenser is not used regularly.
• Ice tastes off-flavored. (See Troubleshooting
guide on page 34.)
If any of these conditions apply to you, follow the
instructions on removing the ice bin.
To remove the ice bin:
1, Pull the covering panel out from the bottom and
then slide it back
toward the rear.
2.
Lift the signal arm so it clicks into the OFF (up)
position. Ice can still be
dispensed, but no
more can be made.
3.
Lift up the front of the storage bin and pull it out.
4.
Empty the ice bin. Use hot or warm water to
melt the ice if necessary. Never use anything
sharp to break up the ice in the bin. This can
cause damage to the bin and the dispenser
mechanism.
5.
Wash with a mild detergent and rinse well. Do
not use harsh or abrasive cleaners or solvents.
When you replace the bin, make sure it is pushed
in all the way or the dispenser will not work. Then
push the signal arm down to the ON position to
restart ice production. Make sure the door is
closed tightly.
20
1-800-253-1301
WITH QUESTIONS OR COMMENTS