Clean it, Plug it in, Install properly – Whirlpool 6ET18GK User Manual
Page 4: Level refrigerator-freezer, Before using your refrigerator
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before Using Your Refrigerator
3-prong grounding
type wall receptacle
3-prong
grounding plug
—-
Refrigerator
power cord '
Clean It
Clean your refrigerator before using it. See
cleaning instructions on page 10.
Plug it in
Recommended Grounding Method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate circuit
serving only this appliance be provided. Use a re
ceptacle which cannot be turned off with a switch
or pull chain. Do not use an extension cord.
See Electrical Requirements and Grounding
Instructions Sheet in your Literature Package.
Leveling screw
Use screwdriver
to adjust
Front roller
Install properly
1. Allow 3 inches (7.5 cm) between overhead
cabinets and refrigerator top.
2. Allow at least an inch (2.5 cm) between the
refrigerator condenser on the back and the wall.
3. Allow '/a inch (1.25 cm) on each side of the
refrigerator for ease of installation.
4.
If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
5. If your refrigerator has an ice maker, make sure
ice maker water supply has been connected.
Refer to Installation Instructions.
Level refrigerator-freezer
1. To raise front, turn screw in direction shown.
2. To lower front, turn screw in direction shown.
3. Check with level.
Lower
Right to raise;
left to lower