Whirlpool EB21DK - Manual (Page 13)

U S I N G Y O U R R E F R I G E R A T O R
Changing the light bulbs
^WARNING
Electrical Shock Hazard
Before removing a light bulb, either unplug
the refrigerator or disconnect the electricity
leading to the refrigerator at the main
power supply.
Failure to do so could result in electrical
shock or personal injury.
To change the refrigerator light:
1. Disconnect refrigerator from power supply.
2. Push lightly on the top, center of the light
shield until the notched tab unhooks from the
Control Panel.
3. Pull down on the light shield until the tab
clears the Control Panel.
4. Lift back hooks of light shield out of their slots.
5. Replace with a 40-watt appliance bulb.
6. Replace light shield in reverse order.
7. Reconnect refrigerator to power supply.
To change the freezer light:
1. Disconnect refrigerator from power supply.
2. Push in sides of light shield until they snap
free.
3. Replace with a 25-watt appliance bulb.
4. Snap light shield into place.
5. Reconnect refrigerator to power supply.
NOTE: Not all commercial appliance bulbs will fit
your refrigerator. Be sure to replace a bulb wKh
one of the same size and shape.
w
Removing the base grille
To remove the grille:
1. Open freezer door.
2. Pull base grille forward to release the support
tabs from the metal clips.
3. Do not remove Tech Sheet fastened behind
the grille.
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close freezer door.
See cleaning instructions for defrost pan and
condenser coils on page 16.
Condenser coils
13